Test And Verify System Function – Fell Marine

VERIFY INSTALLATION

After installation, test the system as described below to ensure installation is done correctly. Always make sure the system is working properly before operating your vessel.

CONNECT

Click the button on your xFOB to connect.

The xHUB will give a sound signal and a GREEN light to indicate a successful connection.

START ENGINE

Start your engine(s).

TEST THE MOB+ IN TWO DIFFERENT WAYS: TEST THE MOB+ BY:

Both described methods are equal in terms of testing stop functionality.

1. DISCONNECT

Click the xFOB to stop the engine
-The system will now shut down the engine and disconnect the wireless system.

RECONNECT AND RESTART THE ENGINE BEFORE TESTING SUBMERSION

2. SUBMERSION

Submerge the xFOB in the sea or the ocean more than 4 inches.
-The system will now go into Man Over Board mode and shut down the engine. After 6 seconds the xHUB will go into override mode. Press the xHUB or xFOB to disconnect the wireless system.

A bucket of water is not sufficient to test the functionality of MOB+. Test the system in the sea or ocean/lake.

Keywords:

Test system, verify system, not working, not turning engine off, not shutting engine off, bucket, water, submerge