WARNING: Disconnect battery cables before attempting to install this product.
Read all instructions carefully before use of this product.
Installation
The installation is simple and below you will find a quick guide.
|
FIND YOUR ENGINE Search for your engine brand in the search field to find wire diagram for your engine. |
| Place the xHub with the antenna at least~ 10"/30cm from other electronics equipment transmitting EMI. The antenna should be in as free space as possible, but where necessary it can be bent up to 45 degrees. |
|
|
|
CONNECT SIGNAL WIRES Connect the signal wires to the existing kill switch wires and the power wires to power. If you have multiple engines, see: Multiple Engine Install |
|
|
DRILL 2- 1/8" / 52MM HOLE Drill a 2-1/8" / 52mm hole in a suitable place adjucant to the drivers position. |
|
|
MOUNT xHUB Insert the xHub to the pre-drilled hole and tighten the nut. |
| Do not push with force on the button when inserting the xHub. This may cause damage to the device. |
|
|
|
CONNECT CABLE & ANTENNA Connect the cables and the antenna to the xHub. |
Keywords:
Installation, dashboard, helm, drill, hole, dimension, antenna placement, mount