WARNING: Disconnect battery cables before attempting to install this product.
Read all instructions carefully before use of this product.
INSTALLATION
The installation is simple and below you will find a quick guide.
![]() |
FIND YOUR ENGINESearch for your engine brand in the search field to find wire diagram for your engine. |
Place the xHUB with the antenna at least~ 10” / 30cm from other electronics equipment transmitting EMI. The antenna should be in as free space as possible, but where necessary it can be bent up to 45 degrees. |
|
![]() |
CONNECT SIGNAL WIRESConnect the signal wires to the existing kill switch wires and the power wires to power. |
![]() |
DRILL 2-1/16” / 52mm HOLEDrill a 2-1/16” / 52mm hole in a suitable place adjacent to the drivers position. |
![]() |
MOUNT xHUBInsert the xHUB to the pre-drilled hole and tighten the nut. |
Do not push with force on the button when inserting the xHUB. This may cause damage to the device. |
|
![]() |
CONNECT CABLE & ANTENNAConnect the cables and the antenna to the xHUB. |
Keywords:
Installation, dashboard, helm, drill, hole, dimension, antenna placement, mount